EBS EPX400, Инструкция по установке и программированию

Страница: 39 / 71

EPX400 – Manual Page 39 / 71
8.3.3. Outputs
Tabs "Output 1 (OUT1)", "Output 2 (OUT2)" and "Output 3 (NC-NO-C)" define the
outputs parameters. The options for the outputs are common and are described in a
single section.
8.3.3.1. Activation mode and timing
Thanks to this option you may choose output operation mode. There are two
operation modes available:
o
bistable – connection follows for indefinite time – up to the moment of
disconnection of power for module or remote command which switches output
off,
o
monostable – connection follows for time defined by user – every 100ms.
8.3.3.2. Conditions
Defines conditions for activating both of outputs. User can set following conditions:
 No connection to server (immediately after detection);
 No GSM signal (immediately after detection);
 Detection of incoming call from defined telephone number;
After selecting this option can be generated CLIP event, if appropriate position
in the “Monitoring” group is set (see item
8.4.6. Event: CLIP ). You can enter
full phone number or only a part of number. The device will detect all
numbers with specified sequence. E.g. if entered number is 1234 , the output
will activate after incoming call from number 1234 56789 or 600 1234 56.
Note: The phone number must be entered without country code (e.g. without
prefix 0048 and +48).