Ebode TAKE 6 IR+RF, Руководство пользователя

Страница: 11 / 88

18-5-2011 11 033000=15301
A
Changing the X10 House Code
The TAKE 6 Remote is set to House Code A by default. In most cases you do
not need to change this setting, unless another X10 system in your area
causes interference.
1. Press the SETUP button until the LED stays lit. Release the SETUP button.
2. Press the numerical key(s) for the House Code selected (1=A, 2=B, ......
16=P).
3. Press the -/-- (13) button to confirm the House Code. The LED will
extinguish.
Note:
The House Code selected must be the same as the House Code used
by your Transceiver Module.
Home Control and entering macro functions
The Macro Function of the TAKE 6 can also be used to control your Home
Automation modules.
4.10 ebode / X10 IR Link RF Receiver
The ebode IR Link RF Receiver (available separately) gives you the possibility
to control all your audio and video equipment with the TAKE 6 anywhere in
your home. The TAKE 6 transmits an RF signal to the IR Link
RF Receiver
module, which then transforms this signal into an IR signal, which is sent to
your device.
Here are some examples of the uses of the IR Link:
• Operate the DVD and satellite receiver from the bedroom, without having
to lay any extra cables.
• Turn up the volume of the radio in the living room while you are in the
kitchen.
The RF signal travels through walls, ceilings and closet doors. Simply connect
the receiver to a wall socket within sight of your equipment: it could not be
easier. Ask your dealer about the possibilities.
5. Troubleshooting
The remote doesn’t work or loses codes entered
• Confirm with your original remote that the equipment works correctly.
• Make sure that you have pressed the corresponding mode key of the
equipment or device that you want to control.
• If the listed code does not work, try the AUTOSEARCH method or enter the
next code of that brand.
• Check that the batteries have the correct polarity position.
• The programming of the remote requires 2 CR2032 batteries (new).
• If the LED is lit permanently, in general it will be necessary to replace the
batteries.
• Set the remote back to factory default.
How to set the TAKE 6 Remote back to factory default
• Press and hold S (8) until the LED indicator (2) lights steadily. Release S .
• Press and hold S (8) until the LED indicator (2) lights steadily. Release S .
• Press and release the 0 key (14) once.
• Press and release the S key (8).
• The LED (2) turns off after few seconds.