QUBO
EN
24
www.eberg.eu
REMOTE CONTROL FUNCTION
1. Press the „TIMER” button when the unit is operating to set the time you desired.
2. Once the set time has elapsed, the unit will turn off automatically.
3. If you press the „POWER” button before the time has elapsed, the setting time will be
canceled and the unit will turn off.
8. SLEEP CONTROL FUNCTION
1. In cooling mode, press the SLEEP button to set the temperature. It increases by 1ºC after
an hour and at most increases 2ºC after 2 hours. In heating mode, press the SLEEP button to
set the temperature.
2. It decreases 1ºC after an hour and at most decreases 2 ºC after 2 hours.
3. Press the SLEEP key again can cancel the setting.
9. SWING
Press this key and the outlet will oscillating, and it will stop when this key ispressed again.
10. ALARM
When the water tank is full,”E4” will be displayed on the display panel. To resume operation,
please remove the rubber cap of the drain hose to drain out the water firstly. The E4 warning
will disappear after draining.
Icon
Function
Cooling
Heating
Dehumidifying
Sleeping
Timer ON/OFF
Temperature
Swing
High Speed
Medium speed
Low Speed
Instruction for the operating keys:
When a remote control signal is transmitted, a transmission icon on the display flashes once,
indicating the signal has been transmitted.
1. Transmission window
2. Liquid crystal display
3. Mode select key:
Select from among the three functions: cooling, heating and dehumidifying. The fast key function
indicates the above operating modes in a cycle when the key is pressed without being released.
However, the transmission icon will not appear until the key is released and the confirmed mode
is transmitted.
4. Setting keys for room temperature:
