7
Your dryer can be used in unattended dwellings such as holiday homes without emptying the
water container. To enable this facility you must use the permanent drainage kit supplied.
Disconnect the
Powerdri from
the power supply
before fitting
the drainage kit.
Using the Permanent Drainage Facility
Fitting the
Drainage Kit
Remove the permanent drainage seal from the
rear of the unit.
To prevent this being mislaid this is attached
to the rear of the panel of your dryer.
Locate the end of the drainage tube with the
bleed hole.
Push this end of the tube onto the permanent
drainage outlet (it may help to dip the end
of the tube in hot water for a few seconds
to soften it) ensuring that the bleed hole is
located at the top.
Ensure that the tube is securely attached
to the drainage outlet and route the
pipe ensuring that:
•
The pipe is not kinked nor has an
excessive number of bends in it.
•
The level of the pipe does not rise
above the level of the machine's
drainage outlet.
Looking after your Powerdri
Your Powerdri requires very little maintenance, however, to maximise performance clean the
filter every month (replacing every 3 to 4 months dependent upon usage) and every 6 months
you should check the drainage system as follows:
Using a standard matchstick or small plastic bottle brush, remove any residue from the water drain outlet above
the water container (left hand side).
Pull out the permanent drainage bung from the rear of the unit. This should then be pushed in and out a few
times to remove any build up inside the drain tray (have a cloth or other absorbent material handy to catch the
water). The bung should then be pushed fully home to reseal the drain tray.
Never use solvents or abrasive cleaners to clean your Powerdri.
1
2
