Eaton XNE-GWBR-2ETH-MB, Руководство пользователя

Страница: 171 / 200

9 Appendix
9.1 Data image of the technology modules
XI/ON: XNE-GWBR-2ETH-MB 10/2011 MN05002008Z-EN www.eaton.com
171
Table 80:
Process input
data / check-
back interface of
XNE-2CNT-
2PWM Byte Bit Value Meaning
CNTx
0,2 STS_CNTx_GENERAL_EN 0 Function (CNTx) disabled
1 Function enabled
STS_CNTx_RUN 0 CNTx Counter not ready to count
1 CNTx Counter ready to count
STS_CNTx_SFKT_EN 0 Special function of Z disabled for CNTx
1 Special function of Z enabled for CNTx
STS_CNTx_LOGMSG 0 Curent status of MSG bits
1 Status of MSG bits are frozen
STS_CNTx_DIR 0 CNTx Counter counts down.
1 CNTx Counter counts up.
Ax, Bx, Zx 0 Digital input is LOW.
1 Digital input is HIGH.
1,3 MSG_CNTx_CMP0 0 No message active that reports that the
compare value CMP0 has been reached.
1 The counter CNTx reports that the compare
value CMP0 was reached.
MSG_CNTx_CMP1 0 No message active that reports that the
compare value CMP1 has been reached.
1 The counter CNTx reports that the compare
value CMP1 was reached.
MSG_CNTx_UFLW 0 No message active that reports that the lower
count limit has been reached.
1 The counter CNTx reports the lower count
limit was reached.
MSG_CNTx_OFLW 0 No message active that reports that the upper
count limit has been reached.
1 The counter CNTx reports the upper count
limit was reached.
MSG_CNTx_ND 0 No message active that reports a zero
crossing.
1 The counter CNTx reports a zero crossing.