8
XFG1 HD IP Fixed Optical Camera Station
XFG1 HD IP OPtIcal FIXeD camera
TMOX001.A September 2021 www.eaton.com
Warning:
this cover must not be removed under
any circumstances, until at least 5 minutes after
the power source is disconnected.
Fig.3 Gaining access to the Terminals
Slide the camera
from the enclosure.
See Note 7.
Loosen the grub screw
before attempting to unscrew
the cover.
See Note 6.
7.0 MAINTENANCE
Due to the rugged construction of the unit, little or no
maintenance should be required during the working life
of the unit. GRP will resist attack by most acids, alkalis
and chemicals and is as resistant to concentrated acids
and alkalis as most metal products.
However, if abnormal and/or persistent unusual
environment conditions occur due to plant damage or
accident etc, then a visual inspection is recommended.
If the unit requires cleaning, then only clean with a damp
cloth to avoid electro-static charge build up.
Recommended inspection interval: 6 Months to ensure
trouble free operation and extended product life.
It is recommended that, where the unit is exposed
to regularly extreme weather conditions, the ‘O’ ring
weather seal in the removable window is replaced every
fi ve years. If the cover/lens assembly grease needs to
be re-applied, a PFPE (Perfl uoropolyether) based grease
such as Krytox GPL203 by DuPont or Perfl uorolube 22/6
by Performance Fluids Ltd should be used, to prevent
damage to the O-ring.
Fixings and fastenings should be checked for tightness
and integrity as part of the 6 monthly inspection
intervals. All cable entries and cables should be checked
for integrity at these points also.
Extreme and harsh environments may require more
frequent inspection and maintenance checks. Therefore,
the end user or installer shall ensure that this equipment
is protected against external infl uences which could
adversely affect the explosion protection or contact
the manufacturer if in doubt of the suitability of this
equipment in the environment in which it is to be
installed.
8.0 INSPECTON SUMMARY
At every Inspection interval, carry out the following:
• Clean the exterior of the unit.
• Check the ‘O’ ring weather seals and replace if
necessary.
• Check the integrity of all cable entries and cables.
• Check condition & tightness o all fasteners on the unit
and any mounting points.
• Use only Eaton approved spare parts.
