EATON xChargeIn UDP Programmers Guide V 2.01
EATON xChargeIn, UDP Programmers Guide V 2.01
7
© EATON 2018
2.3
Recommended communication buildup scheme
The following scheme illustrates a recommended process for the detection
and the initial communication buildup:
1)
Send “
i
” to network address/port 7090
2) Wait for t_UDP_pause
If a device sends a response, continue with step 3 otherwise return to
step 1.
3)
Send “
report 1
” to IP address of charging station/port 7090
4) Wait for t_UDP_pause
5)
Send “
report 2
” to IP address of charging station/port 7090
6) Wait for t_UDP_pause
7)
Send “
report 3
” to IP address of charging station/port 7090
8) Wait for t_UDP_pause
Now the complete device data and all acquirable information is available to
the application.
2.4
RFID authorization
The following section provides information regarding the RFID authorization
function as well as a method to detect if this function is enabled.
All variants of the xChargeIn charging stations save the RFID tags in a
whitelist, which can be deleted by performing a special reset or extended by
using the master RFID card. For more information please refer to the
"operating instructions".
2.4.1
xChargeIn S-series
xChargeIn S-series has no dedicated setting to enable/disable the RFID
authorization. A charging station with an empty whitelist is permanently
unlocked and a charging station with at least one entry in the whitelist is
locked. The data shown in the following table can be acquired using the
command
report 2
.
