Eaton VORAD, Руководство по обслуживанию

Страница: 14 / 32

11
Service Procedure
Antenna Assembly Installation
Procedure-
1. Install the Antenna Assembly onto the bumper or the
Antenna Assembly mounting plate.
2. Install the four (4) mounting capscrews and tighten prop-
erly.
Note: Specific torque values vary according to OEM cap-
screw usage.
3. Reconnect the Antenna Harness with dielectric grease on
the connection.
4. Perform the Antenna Assembly Alignment Procedure
(see page 34).
5. Torque the Antenna adjusting screws to 24-26 lbs. in.
(2.7 - 2.9 N•m).
6. Install the Antenna fairing.
Final Check
Make sure the mounting capscrews are properly tightened.
Make sure the Antenna Alignment is correct.
Make sure the Antenna Harness is connected and locked.
Make sure the Antenna adjusting screws are properly tight-
ened.