Eaton Tripp Lite SmartPro Series, Руководство для продвинутых пользователей

Страница: 47 / 58

Tripp Lite by Eaton SmartPro Advanced User Guide 614-40195—Rev 01 35
Table 23. Replacing the Internal Battery Steps (Continued)
3 - Remove the metal protection cover in front of the battery (three screws).
4 - Pull the plastic tab to remove the battery pack and replace it.
Take care not to reverse the po (red) and - (black) when connecting the batteries as this will destroy the
device.
TTeessttiinngg N Neew w B Baatttteerriieess
To test new batteries:
1. Charge the batteries for 48 hours.
2. Press any button to activate the menu options.
3. Select "CONTROL" then Start battery test. The UPS starts a battery test if the batteries are fully charged,
the UPS is in Normal mode with no active alarms, and the bypass voltage is acceptable. During the battery
test, the UPS transfers to Battery mode and discharges the batteries for 10 seconds. The front panel
displays "BAT TESTING".
66..55 R Reeppllaacciinngg tthhee U UP PS S EEqquuiippppeedd w wiitthh aa H HoottS Sw waapp M MB BP P
Table 24. Replacing the UPS Equipped with a HotSwap MBP Steps
The HotSwap MBP module makes it possible to service or even replace the UPS
without affecting the connected loads (HotSwap function).
Maintenance
1. Set switch (45) to Bypass position. The red LED on the HotSwap MBP module
goes ON, indicating that the load is supplied directly with AC input source
power.
2. Stop the UPS by pressing the button on the UPS control panel. LED (43)
"UPS ON - OK to switch" goes OFF, the UPS can now be disconnected and
replaced.
UPS Maintenance