2
SVPD Programming Guide
www.eaton.com/lightingsystems
Quick Reference Guide
This guide is provided as a quick reference. Please review this document in its entirety prior to adjusting settings.
ISHH-01
ISHH-02
Function
Order
Adjustment
Time
Adjustment
Recommendation
Special Instructions
Save Setting Command
Sensor Video
Time
enable/
disable
daylight
dimming
1
individual fixture
For fixtures located
in non-daylight
zones, disable
daylight dimming
00:58
set
occupancy
detection
scene level
2
all fixtures in space
Set all fixtures in
the space to the
desired ON/OFF
configuration and
desired light level
then save at each
fixture
1:39
2:12
set
unoccupied
scene level
3
all fixtures in space
Set all fixtures in
the space to the
desired ON/OFF
configuration and
desired light level
then save at each
fixture
1:39
2:12
set
occupancy
energy saver
scene level
4
individual fixture
Set all fixtures in
the space to the
desired ON/OFF
configuration and
desired light level
then save at each
fixture
1:39
2:12
set
occupancy
time-out
any
time
individual fixture
-
3:50
set
occupancy
sensitivity
any
time
individual fixture
-
enable/
disable
daylight
switching
any
time
individual fixture
-
Sensor Video
Integrated sensor and
remote overview
The SVPD integrated sensor is installed in the selected fixture at the
factory. Once power is applied, the sensor will begin operation after
a 1 minute power up period. Motion activity will cause the sensor’s
red LED to flash. The sensor’s red LED may also flash differently
during programming.
The SVPD integrated sensor’s default behavior is adjusted using the
ISHH-01 programming remote. The ISHH-02 personal remote is also
available to allow for scene recall and temporary light level changes.
= Perform this adjustment
any time of day or night
= Perform this adjustment
at night or when no
daylight is present
= Do not move for 10 seconds
prior to performing the
"SET" command