Intelligent Technologies (
IT.
) QSNAP
6
Pub. No. MN05001001E
February 2002
Power Source
The
IT.
QSNAP is designed for use with 24V DC power. The QSNAP uses power from two
sources when operating properly; these sources are the QCPort subnet and the Eaton’s
Cutler-Hammer Intelligent Technologies (
IT.
) Electromechanical Starter. This allows the
QSNAP to detect and communicate to the user that the
IT.
starter does not have 24V DC
power, signaling a fault or an E-Stop.
The main power that powers the communication is from QCPort, as illustrated in
Table 5
.
Some power is required from the starter for communication to be present between the
Intelligent Technologies (
IT.
) Electromechanical Starter and the QSNAP.
The power for the
IT.
starter must be connected to the starter terminal.
Table 5: Power Requirements
When a power supply is chosen for QCPort, take into account the load on QCPort. When a
power supply is chosen for the starter(s), size it for the load of the starter(s) using the
IT.
Contactor and Starter User Manual
(Publication No. 49400). Refer to the
IT. QCPort System
Install and Planning Guide
(Publication No. MN05001002E) for more information on how to
size the power supply for the QCPort system.
The power for the Eaton’s Cutler-Hammer Intelligent Technologies (
IT.
) Electromechanical
Starter must be connected to the Intelligent Technologies (
IT.
) Electromechanical Starter
terminal, as illustrated in
Figure 3
.
Figure 3: Starter Interface Connection
Current Source
Load
QCPort
TBD
IT.
Starter
TBD
To Starter
To QSNAP
Optional
E-Stop
+
24V DC
–
Содержание QSNAP
Страница 28: ...Intelligent Technologies IT QSNAP 24 Pub No MN05001001E February 2002 ...
Страница 29: ......
