Power Xpert
9395P Field Installed UPM Mechanical Installation Manual
S
P-164000503 Rev 1
4-1
Chapter 4
Field Installed UPM Installation
4.1
Preliminary Installation Information
W
A
R
N
I
N
G
Installation should be performed only by qualified personnel.
A
V
E
R
T
I
S
S
E
M
E
N
T
!
L’installation ne doit être effectuée que par du personnel qualifié.
Refer to the following while installing the Field Installed UPM (FI-UPM):
S
Chapter 3 for cabinet dimensions, equipment weight, wiring and terminal data, and
installation notes.
S
Do not tilt the cabinet more than
"
10° during installation.
S
The FI-UPM cabinet is installed on the left side of the UPS cabinet.
S
The FI-UPM cabinet is shipped with a debris shield covering the ventilation grill on
top of the unit. Do not remove the debris shield until installation is complete.
However, remove the shield before operating the UPS system. Once the debris
shield is removed, do not place objects on the ventilation grill.
S
A FI-UPM is always designated as UPM 4.
4.2
Unloading the FI-UPM Cabinet from the Pallet
The FI-UPM cabinet is bolted to a wooden pallet supported by wood skids. To remove
the pallet:
W
A
R
N
I
N
G
The FI-UPM cabinet is heavy (see Table 3‐1 on page 3-2). If unpacking and unloading instructions are not
closely followed, the cabinet may tip and cause serious injury.
A
V
E
R
T
I
S
S
E
M
E
N
T
!
Les sections de
l’onduleur sont lourdes (voir le tableau 3-1). Suivre attentivement les instructions de
déchargement et de déballage pour éviter de renverser les armoires, ce qui pourrait causer de graves
blessures.
C
A
U
T
I
O
N
S
Do not tilt cabinets more than 10° from vertical.
S
Lift the cabinet only with a forklift or damage may occur.
A
T
T
E
N
T
I
O
N
!
S
Ne pas incliner les armoires à plus de 10 degrés de la verticale.
S
Ne soulever les armoires qu’à l’aide d’un chariot élévateur pour éviter de les endommager.
Figure