Eaton i-on40, Руководство по установке

Страница: 26 / 36

Programming i-on40
Page 22
The control unit loads the factory default
access codes:
User 1: 1234, Installer: 7890.
(All other users have been deleted.)
After a short pause the keypad display shows
the time and date. The red LEDs glow to show
an alert that the panel lid is open.
The
sounders operate.
6. Remove the short from the Reset Codes pins.
7. Reconnect the battery.
8. Close the control unit lid (to restore the tamper
switch).
9. Key in the Master User code, 1234, to silence
the sirens.
The LEDs around the navigation glow red to
show an alert for a tamper and a missing
battery.
Press

twice to (if necessary) acknowledge
any alerts.
To force the control unit to check the battery:
10. Enter Installer Menu and then leave it again.
The navigation key LEDs should now glow
green.
Note: The log is protected and cannot be erased
by the Installer.
Restoring Factory Defaults
If you wish to restore all factory default options
then:
1. From the Installer Menu select System Options
– Restore Defaults – Factory Defaults
.
The display asks for confirmation.
2. Press

to load defaults.
(Press

to go back to the Installer Menu
without changing defaults.)
The display asks you to select Partition Mode
or Part Set Mode.
3. Press A or B to select the desired mode.
The display asks you to select the zone wiring
type.
4. Press

or

to display the desired wiring
type on the bottom line of the display and then
press

to select it.
The system loads all defaults except for
Access Codes and the Log.
The display shows:


5. Leave the Installer Menu to save the change
(press

until the display shows
“

” then
press

).