Setting and Unsetting
Page 20
You must hold down the button you intend to press for at least three
seconds to activate its function.
See page 57 for details of programming the * button.
Setting the system
1.
Make sure the system is in standby.
2.
Press and hold the Set or Part Set button, as required. The Set or Part
Set LED flashes red three times.
If there is a fault (for example a zone is active), all four LEDs glow red
for three seconds.
3.
You will hear a continuous exit tone (unless the system is configured
for silent or instant setting). The system sets as described in step 7 on
page 16.
4.
The Set or Part Set LED glows green for three seconds. This is your
confirmation that the control unit has set the system.
Unsetting the system
Note:
An administrator can disable the ability for remote controls to unset
the system (see page 60).
To unset the system:
1.
Enter through the entry route designated by the installer.
2.
Depending on how the system is configured, you may hear an entry
tone. If you hear the tone, you will have limited time to unset the
system before it generates an alarm.
3.
Press and hold the Unset button. The Unset LED flashes red three
times.
4.
The Unset LED glows green for three seconds. This is your
confirmation that the control unit has unset the system.
Querying the set/unset status
1.
Press and hold the Query button. The Query LED flashes red three
times.
2.
The Full Set, Part Set or Unset LED glows to show the current status
of the system.
