Page
2
Step 2: Enter installer mode
Installer mode gives you access to
the installer options. To enter installer
mode:
1. Make sure the standby screen is
displayed (see the previous page).
2. Enter the installer code you
created.
3. If you are prompted for a user
code, enter that too.
4. The bottom line displays
Detectors/
Devices, which is the first option in
the menu:
INSTALLER MENU
Detectors/Devices >
How to select options
To select an option, press
u
or
n
(on
the Navigation key) until the name of
the option you want is displayed, then
press
.
Selecting an option may display a
menu of further options. For example,
selecting
Detectors/Devices displays
the first option in the
Detectors/
Devices menu (Detectors):
DETECTORS/DEVICES
Detectors
Press
to exit a menu or to cancel an
action.
Some options require you to press
or
to change the setting.
Note: A menu map of all installer
options is available on page 6.
Step 3: Add door contacts
(DET-RDC) or PIRs (XCELRPT)
1. Open the cover of the door contact
or PIR and insert the battery.
2. Close the cover.
3. From the top level of the Installer
menu:
a. Select
Detectors/Devices.
b. Select
Detectors.
c. Select
Add/Del Detectors.
d. Use
u
or
n
to choose a zone
number, then press
(each
door contact and PIR needs
a different zone number). The
display shows:
Activate
detector tamper
4. Open the cover of the door contact
or PIR.
5. The display shows “Detector
assigned to Zone xxx” and the
signal strength (0-9). Each zone
represents one device.
6. Repeat the above steps for each
door contact and PIR.
Step 4: Add external radio
sirens (SDR-REXT-G2)
Please refer to the installation
instructions provided with the siren.
At the step where you need to teach
the control unit the siren’s identity:
1. Make sure that the batteries are
not connected.
2. From the top level of the Installer
menu:
a. Select
Detectors/Devices.
b. Select
External Sirens.
c. Select
Add/Del Siren.
d. Select a siren number (each
siren needs a different number).
The display shows:
Activate
Siren Tamper
