Eaton Hydrowa, Инструкция по эксплуатации

Страница: 21 / 149

Instruction Manual
Page 9
Never protect the piston rod with plastic foil but use air breathing
material like Denso-tape instead.
5.2.3 Storage checklist
During storage verify the following items monthly, adjust immediately if
necessary and document accordingly on the checklist:
1. Verify if preservation oil, grease or wax (Rust-Ban 397 or equivalent,
suitable for the environment) is still present on all blank surfaces.
2. Check if connections are properly sealed and that there are no leakages
(oil spill / nitrogen pressure drop below 3 bar).
3. Check cylinder for paint-damages. Any damage to the paint should be
repaired immediately. Make sure the same paint is used according to the
specifications of the cylinder.
4. Check if piston rod protection is in place.
Storage more than 6 months after FAT
New pressure test required before installation.
Storage more than 2 years after FAT
The cylinders should be disassembled, cleaned, seal replacement and testing
before installation / commissioning. Disassembly of cylinders MUST be done
by qualified Eaton personnel. Every single part should sealed, greased, oiled
or waxed to prevent rust, damage or any other type of threat.