Eaton
1000 Eaton Boulevard
Cleveland, OH 44122
United States
Eaton.com
Eaton’s Wiring Devices Division
203 Cooper Circle
Peachtree City, GA 30269
Eaton.com/wiringdevices
© 2017 Eaton
All Rights Reserved
Printed in USA
Publication No. TD610079EN
December 2017
Eaton’s Wiring Devices
Home automation hub
Figure 6: Paper clip pressing the recessed push
button
Other things to check when troubleshooting:
• Ensure that the home has internet connection.
• If the SSID menu closes before it has successfully
connected, you must shut down and restart the
Home automation hub.
If the problem persist after following the trouble
shooting steps, please contact tech support.
Specifications
I/O ports
USB
2
General
Processor
Broadcom ARM7
Operating system
Linux
Memory
1 GB DRAM, 8 GB Flash
Power
3.5 W (700 mA at 5 VDC)
Operating temperature 41 to 113°F (5 to 45°C)
Relative humidity
10 to 90%, non-condensing
Dimensions
(W x H x D)
3.85 x 5.98 x 1.32 in.
(9.77 x 15.18 x 3.35 cm)
Contact information
Eaton
Electrical Sector
203 Cooper Circle, Peachtree City, GA 30269
www.eaton.com/wiringdevices
Call Technical Support (Eaton Care) at 866.853.4293 or
email [email protected]
Installation and Setup Guide:
Scan code to view the installation & setup
guide for more information.
Regulatory information
Manufacturer:
Eaton
Electrical Sector
203 Cooper Circle, Peachtree City, GA 30269
FCC compliance
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Warranty information
Eaton offers a two (2) year limited warranty on original
Eaton components, from the date of shipment from
Eaton. To view complete limited warranty details, including
limitations and exclusions, www.eaton.com/wiringdevices
Note: If this controller is the primary controller for
your network, resetting it will result in the nodes in
your network being orphaned and it will be necessary
after the reset to exclude and re-include all of the
nodes in the network. If this controller is being used
as a secondary controller in the network, use this
procedure to reset this controller only in the event that
the network primary controller is missing or otherwise
inoperable.
Eaton is a registered trademark.
All other trademarks are property
of their respective owners.
