![background image](http://html2.mh-extra.com/html/eaton/gfx/gfx_installation-and-operation-manual_3682936010.webp)
10
EATON
GFX Installation and Operation Manual April 2020 www.eaton.com
GFX Manual
Installing the GFX
Mounting considerations
•
The GFX shall be fixed using two mounting holes
provided diagonally across the enclosed assembly.
•
Use the standard threaded M5 size screws to affix the
GFX. (Note: Customer shall choose length of the screws
as per mounting base)
•
Mounting torque shall be 1.8±0.2Nm.
Mating antenna details
Use 3V external Active Antenna
Recommended Active Antenna
Part Number: 66800-52, Manufacturer: Trimble Inc.
otee:
N
Antenna interface SMA connector recommended
mating torque - 4-5 inch-pounds.
Antenna interface SMA connector durability- 500 Cycles.
Cautione:
Supply voltage provision is 3V for external active
antenna. Ensure appropriate antenna is chosen for
functioning of GPS.
Recommended wiring practices
•
Confirm the CAN cable is properly terminated using 120
ohm resistor.
•
Use twisted or twisted shielded pair cable for CAN as per
the applicable standard.
•
Verify that the harness is constructed to meet the needs
of the application environment (e.g. shock, vibration,
moisture, temperature, chemicals, and impact).
•
Ensure that the harness is designed and constructed
to minimize induced interference resulting from EMI
coupling between signal wires.
•
Separate power circuits from low-level signals.
•
Provide sufficient clearance from moving parts.
•
Wires routed through holes in the vehicle body/chassis
should use grommets.
•
Avoid sharp metal edges, fasteners, and other abrasive
surfaces or use protective shielding when routing
harness assembly.
•
Route wires to avoid exhaust system components or
other high temperature areas, use appropriate heat
shielding or other insulation where routing is a problem.
•
Avoid routing near wheel wells or provide adequate
mechanical protection to the assembly
•
Use a protective fuse sized appropriately for the GFX
supply current.
Device troubleshooting
The following is a check list, if there is any problem in
the device.
•
Make sure the Power indication Green LED is ON
If Red LED is ON, check the following:
•
Power input is within 5-36V.
•
External Antenna interface- Antenna is not properly
connected or antenna is shorted. Short alert is triggered if
external active antenna draws approximately more
than 19mA.
•
Operating temperature is not exceeding >85
Degrees Celsius.
•
GPS information is not available in corresponding PGNs.
•
IMU Accelerometer and Magnetometer three axis
information is not available in corresponding PGNs.
Warnings
When installing this component, all requirements of the
outlined standard must be fulfilled.
•
This component is designed to be affixed in the
application, and a suitable enclosure should be provided
in the end system.
Declaration of conformity
Hereby, Eaton Corp. declares that this GFX is in compliance
with the essential requirements and other relevant
provisions of the following directives:
1. Electromagnetic Compatibility (EMC) Directive
2014/30/EU
2. Radio Equipment Directive (RED) 2014/53/EU
3. Low Voltage (LVD) Directive 2014/35/EU
4. RoHS 2 Directive 2011/65/EU
Manufacturer Details
Eaton Corporation Hydraulics Operations,
14615 Lone Oak Road, Eden Prairie MN 55344,
United States.