DRAFT - 07 March 2016
DRAFT - 07 March 2016
INM MTL GECMA WS display rev 2
12
6 .2 .2 Mounting
NOTE:
It is suggested that two persons are used to mount the display module. One at
the front of the panel to hold it in position safely and one at the rear to fit any
necessary mounting brackets and securing nuts.
NOTE:
Leave any protective film in place on the screen until all installation work is
completed. This helps to avoid the chance of scratches or other damage to the
display screen during the installation.
Fit the display module into the panel cut-out and align the mounting studs with the
holes in the panel.
Ensure that no wires are trapped,
then press the module fully into
position. Fit any backing brackets supplied then begin fitting the securing screws.
NOTE:
The mounting method is different for the MTL GECMA 22” WS display panel,
as this unit uses additional brackets behind the mounting panel, which is then
secured with nuts on the display module’s studs.
Use finger pressure to tighten the M5 hexagon socket screws on all four of the
corners
before using any tools to tighten the screws. This ensures that the display
module is properly seated on the panel and avoids the danger of distorting the bezel
by initial over-tightening when incorrectly seated.
Finally, tighten all of the M5 hexagon socket screws to a torque of 1.0 Nm to ensure a
proper seal around the display panel.
6 .3 Electrical installation
Rear view of an enclosure showing a display module
and the associated components mounted on it.
