Eaton ConnectUPS Web/SNMP Card, Быстрый старт

Страница: 4 / 26

Eaton ConnectUPS Web/SNMP Card Quick Start Instructions 164950185—Rev D 4
Section 1 Installation Checklist
1. Verify that the following items are available:
o
ConnectUPS Web/SNMP card package contents (card, cable, Quick Start
Instructions)
o
Phillips
®
screwdriver
o
Available USB port on a computer running Microsoft
®
Windows
®
o
Web browser (Microsoft Internet Explorer
®
version 8.0 and higher,
Mozilla
®
Firefox
®
, or Google Chrome™ are recommended)
2. If you are going to use Dynamic Host Configuration Protocol (DHCP), provide
your local network administrator with the card's MAC address. The MAC
address is located on either the shipping box label or the label on this card.
o MAC Address _____________________________________________
3. If you are not going to use DHCP to provide any of the settings listed below,
contact your local network administrator for the settings.
In the table below, check the DHCP check box or enter the values for manual
configuration.You will reference this data later in the procedure.
4. If you need e-mail functionality, obtain the SMTP mail server's IP address or
host name. If using the SMTP host name, verify that you also have the
Name Server IP address (see Step 3).
o
SMTP (mail server) IP Address
or Host Name
_____________________________________________
Item DHCP* Manual Configuration
IPv4
o
Card IP Address: ________________________
Netmask: ________________________
Gateway: ________________________
DNS – Name Servers
o
Name Server #1: ________________________
Name Server #2: ________________________
Name Server #3: ________________________
DNS – Domain
o
Domain: ________________________
* The network administrator normally sets up the DHCP server to provide a static IP address each time
the card makes a DHCP request.