Eaton 93PM IBC-LHW, Руководство по установке

Страница: 41 / 78

Eaton 93PM Universal Integrated Battery Cabinet (IBC-LW and IBC-LHW) Installation Manual P-164000541—Rev 04 31
Figure 9. Removing the Pallet Skids and Supports – Eaton 93PM IBC-LW or Eaton 93PM IBC-LHW
Jacking Bolts
(2 places front)
(2 places rear)
Floor Protectors
(2 places front)
(2 places rear)
Cabinet Mounting Bolts
(4 places front)
(4 places rear)
Front
Support
Cabinet
Support Bolts
(1 at each corner)
Pallet Skid
Skid Mounting Bolts
(6 places left side)
(6 places right side)
Rear Support
Left Support
Cabinet Mounting Bolts
(4 places left side)
(4 places rright side)
Right Support
Front Door
Front Door Mounting Bolts
(4 places top)
(2 places bottom)
CAUTION
CABINET MAY FALL. Do not loosen the hardware attaching the front supports to the cabinet base. The cabinet
must be lowered by the jacking bolts before the supports can be removed.
8. Carefully and evenly lower the cabinet by turning each jacking bolt consecutively two full turns
(maximum) until the casters contact the floor and the cabinet is no longer supported by the jacking bolts.
9. After the IBC is resting on the floor, remove the jacking bolts and floor protectors. Recycle them in a
responsible manner.
10. Remove the cabinet support bolts fastening the left, right, front, and rear supports together (see Figure 9 ).
11. Remove the cabinet mounting bolts holding the left, right, front, and rear supports to the cabinet base.
Installation