Eaton 50 VCP-TR16, Инструкция по использованию

Страница: 57 / 76

Instruction Book
Effective: November 2017 Page 51
IB131016EN For more information visit: www.Eaton.com
Table 6.1 Inspection and Maintenance Procedures
No./Section Inspection Item Criteria Inspection Method Corrective Action
1. Insulation Drive Insulator
and
Molded Pole Unit Support No dirt
No cracking Visual Check
Visual Check Clean with lint-free cloth
Replace cracked unit
Insulation
Integrity
Main Circuit to Ground Withstand Hipot Tester Clean and retest or replace
Between Main Circuit Terminals Withstand Hipot Tester Clean and retest or replace
Controls Circuit to Ground Withstand Hipot Tester Clean and retest or replace
2. Power Elements Vacuum Interrupters Contact Erosion
Visibility of Mark
(Up to 25Ka) Visual:
Close the breaker
and look for the
mark on moving stem from the
rear of the breaker (see Figures
6-1 & 6
-
2).
If the mark is not visible,
replace pole unit assembly
Contact wipe visible
(Up to 25Ka) Visual:
Close the breaker and look for
indicator (see Figures 6-2, 6-3,
6.4).
Replace pole unit assembly if
the indicator is visible
Contact wipe/erosion
(40Ka) Refer to 6-5.1 details Replace pole unit 87mm &
Replace pole unit assembly
Adequate Vacuum See Section 6-5
Dirt on ceramic body Visual Check Clean with dry lint-free cloth
3. Control Circuit Closing and Tripping Device Smooth and correct
operation by control power Test closing and tripping of the
breaker twice Replace any defective device,
identify per trouble-shooting
chart in this section
Wiring Securely tied in proper
place
Visual Check Repair or tie as necessary
Terminals Tight Visual Check Tighten or replace if necessary
Motor If required Functional Test Replace as necessary
Tightness of Hardware No loose or missing parts Visual and tighten with appropriate
tools
Tighten or reinstate if
necessary
4. Operating
Mechanism
Dust or Foreign Matter matter No dust or foreign Visual Check Clean as necessary
Lubrication Smooth operation and no
excessive wear Sight and feel Referr to Figures 6-5, 6-6 and
paragraph 6-10
Deformation or Excessive Wear No excessive deformation or
wear Visual and operational Remove cause and replace
parts
Manual Operation Smooth operation Manual charging closing and tripping Correct per troubleshooting
chart (Table 6.4) if necessary