3
Configuration guide
Eaton 1250W / 1500W / 1800W Inverter Operation and Installation Guide
IM SP180164 / Rev D www.eaton.com
To adjust the charging current setting:
By default, the charging current is 40A.
To change the charge current setting:
1. Press and hold the
green power button
for approximately 2 seconds. The inverter will beep and the display will flash
the input voltage. Press the
SELECT
button until “40” (or current value setting) is displayed. Press and hold the
POWER
button for 5 seconds.
2. Press the
SELECT
button to switch between the different current ratings in [Amps].
•
40 – 2 – 5 – 10 – 20
3. To choose a new setting, stop at the desired value, press and hold the select button for five seconds to memorize the
setting.
4. Confirm the new setting by not touching the inverter for approximately 5 seconds to return to inverter setting display
mode. Press
SELECT
button multiple times to confirm new setting(s).
Unit performance can be optimized using Table 2.
Figure 2. Setting flow chart
Showing all display and setting adjustment options
