12
Operation
First time use - curing the plate
During manufacturing, the cooking surface is coated
with a non-toxic paint This paint will come off
completely over time Its purpose is purely to help
protect your oven during transport and storage
Coat the cooking surface with canola oil or cooking
oil Light the oven Leave the oven with all burners
on low for about 30 minutes Paint may come off at
this time After cleaning, the cooking surface is now
cured and ready for use This process only needs to
be done the first time you use the oven
Preparing the cooking surface
It is recommended to coat the cooking surface with
cooking oil before lighting as this will help keep the
food from sticking to the cooking surface Turn on the
burners and leave them burning at a low temperature
(“LOW”) to preheat the cooking surface
While cooking
Flames caused by fat dripping from the food could
damage the food, causing the food to burn easily
Remove excess fat from the meat if this becomes a
problem Removing the meat from the flames is also
advisable Always monitor your cooking and avoid
leaving the oven unattended while cooking
After cooking
To turn the oven off, it is best to turn off the cylinder
first, and allow all the gas remaining in the hose to
burn off, this will only take a couple of seconds Then
turn off all burners
IMPORTANT INFORMATION
• This product is for outdoor use only
• Do
NOT
use indoors
• Do
NOT
use below ground level
• Do
NOT
store gas cylinders below
ground level
• Gas is heavier than air so if a leak occurs the
gas will collect ata low level and could ignite in
the presence of a flame or spark
• Do not store or use gas cylinders on their side
as this could allow liquid gas into the supply
pipes with serious consequences
• Leak test your appliance before each use
Leak test the hose connections each time you
reconnect the gas cylinder
• Always turn off the gas at the cylinder when not
in use
• Open the door of the frame to inspect the
hose before each use If there is evidence of
excessive abrasion or wear, or the hose is cut it
must be replaced prior to the appliance being
put into operation
• Only use hose supplied from
the manufacturer
You must have the correct gas cylinder, regulator
and hose for appliance to operate safely and
efficiently. Use of anincorrect gas cylinder, regulator
or hose is dangerous and will void the warranty on
this product.
