EASYSTEAM ANAPA, Руководство по установке и обслуживанию

Страница: 19 / 36

As a binding solution, you should use clay puddle or ready-to-use furnace solution made of red clay:
Furnace solution Borovichi (“ СЭВ ” company)
Furnace solution from Kostroma (“ Макаровыхъ ” company)
other binding solutions that do not contain any harmfull impurities and can be used in
conditions of high temperatures
It is prohibited to install the brick cover of the chimney without inner metal pipe!
Every wall should be connected to each other. The cover is installed directly on the
prepared foundation. The shield in the sweating room should be 30-50 mm higher than the furnace
top lid (not including steam or smoke pipes).
It is not recommended to make the distance between sti ening bars and protective shield more
than 30 mm as it would cause ine cient warm-up of the cover and longer heating-up of the
banya.
Lower convection doors are installed at the minimum distance from the floor. Install convection
doors on every side of protective shield in order to achieve maximum convection e ect.
Minimum recommended area for lower convection doors is 500 cm and 600 cm for upper ones.
The protective heat shield in the front of the furnace should be as high as the full height of the
room.
Around and across the heat-control shutter stem, it is required to make a 5 mm manufacturing air
clearance to compensate temperature expansions.
To cover the combustion flue or the heater, utilize two 50 х 50 mm iron angles.
It is recommended to reinforce the brick cover with 2-3 mm steel wire every 4-5 tiers.
To cover the top of the furnace with bricks, place 50 х 50 mm iron angles on side walls of the
protective shield and put bricks on them, make notches in corners where furnace components
are
While doing brick covering, make convection canals at the top of protective shield to ensure hot
air output.
When installing the furnace with a brick cover and covered top, decorate the top with stones (lay
50-70 kg). When doing so, pick bigger stones in comparison with the width of the gap between
the furnace and the shield. In this case, convection flows would go through clearances between
stones.
1
19