28 . If the optional Swing-Away Shadow Tray was
ordered, place the tray upside down as shown.
Flip the chrome arms as shown, remove 4 bolts
from bottom of the tray. Place arm brackets onto
tray and line up holes in arm bracket with holes
on the tray. Insert 4 bolts and tighten securely.
29 . Lock the casters, loosen the knobs on the
tray receiver all the way then, flip open gray tabs
until it clicks. Insert the two tray arms into the
tray bracket on the bottom of the tray as shown.
(for information on Shadow Tray adjustments see
pg. 20).
30 . If the swing away shadow tray was ordered,
using a wrench, remove the nut from the bolt on
the tray arm and discard the nut. Make sure all
other hardware stays on the bolt.
Caution: After placing the tray into position,
ensure the ratchet handles on the side of the
tray are tightened securely.
Assembly
Page 12
Controller Usage
12 . Supine Mode
Caution: A properly fitted and adjusted headrest MUST
be used with the supine option.
The Bantam Medium with Supine Option functions both
as a sit-to-stand stander and a supine stander. It may be
safely switched between modes at will, without
removing the user from the stander.
Caution: Do not make back angle adjustments while in
supine mode.
• The unit is locked into supine mode as soon as the
controller is set in that position.
• The foot bracket supports and back support are
locked in relation to each other in Supine mode.
When in partial supine or full supine the user can
be elevated to an upright position or descended to
a reclined position.
• If the unit is locked in supine mode, you must only
elevate the unit to the point where the footplate bracket
comes perpendicular to the floor. DO NOT CONTINUE
TO ELEVATE THE UNIT PAST THIS POINT. Forcing the
unit to elevate past its stopping point could result in
damage to the unit.
• The unit is equipped with a Mechlok bypass. This
mechanism prevents component damage in the event of
over-travel while locked in “Supine” mode. If in supine
mode with the legrest assembly up against the seat
column (vertical), the Mechlok bypass will be activated. If
you wish to maintain supine position while lowering the
seat, it is necessary to pull on the supine assist handle
a few degrees while lowering the unit until the Mechlok
bypass de-activates. If this is not done, the stander will
behave as though it is in “Sit-to-Stand” mode, allowing
the user to return to a seated position.
Caution: When in supine mode, if the limit is reached
where the foot bracket is perpendicular
to the floor, but the user wishes to continue to a
straighter standing position you must change
the controller to sit to stand mode . This will allow
the user to continue toward upright standing
without damaging the unit .
12.
Adjustments & Usage
Page 19
Knobs
