Assembly
Page 14
Controller Usage
Go to easystand.com/videos for a short video on the
controller usage.
Designed with ease of use and the safety and comfort of
the user in mind, the Controller (as shown) is the single
point of operation for the supine option.
8 . The Controller has 3 positions: Neutral, Sit-to-Stand,
and Supine.
9 . There is a spring loaded safety collar (red colored)
which prevents inadvertent switching between modes.
It must be lifted upward into the shift knob before the
mode can be changed.
10 . Neutral Mode
• The controller should only be set in the neutral
position when changing between the sit to stand
and supine positioning modes.
• Do not leave the controller in neutral position with
a person in the Bantam.
• The neutral position allows the foot bracket
supports, and the back support to move freely at
the hip and knee pivot points to go into partial
supine or full supine.
Caution: If the back angle adjustment has been reclined
prior to switching into Neutral mode, the amount of
recline will remain relative to its previous adjustment.
For example, if the back is adjusted to 10 degrees
reclined while the patient is seated, the backrest will be
10 degrees BELOW parallel with the seat if the unit is
placed in full supine. For the comfort and safety of the
patient, the operator or attendant must be fully aware of
back angle adjustment and should confirm “same color”
settings on the seat depth and following arm BEFORE
switching to Neutral or Supine modes.
Important: All seat depth and following arm
adjustments should be made with the Controller in
the Sit-to-Stand mode .
8.
9.
10.
Adjustments & Usage
Page 17
34 . Insert each knee pad assembly into the tube
along the seat post. Depress the spring button
to allow the bracket to slide into place, advance
until the spring button locks into place. Tighten
knobs securely. For Swing-Away knees, place
into the tube, and tighten knob securely.
35 . Remove knobs (bolts on standard knees)
from the knee pads, place the knee pads on the
bracket with the larger end of the pad to the
outside and the seamside down. Place into
desired position and tighten securely.
36A . Remove bolts and nuts from the pump
handle socket. Place pump handle socket onto
pump and align holes. Place bolts through top of
the pump handle socket and place nuts on
bottom. Tighten securely.
36B . Remove bolts from pump handle top. Place
pump handle top on pump handle and align
holes. Tighten securely.
36A
36B
