EASYDIVE
di Fabio Benvenuti - Via dell’Industria 13 Int. 6 – 48015 Montaletto di Cervia (RA) -
Tel/Fax + 39 (0)544/962923 cell. + 39 338/9994219 - Web:
www.easydive.it
E-mail: [email protected]
Assembly Procedure
Verify from the Camera Menu that the USB output is set to PTP (where
necessary, in some cameras this is not necessary)
Insert the mini USB connector of the interface to the camera
(see image
below)
Insert the remote shutter control to the camera (
see image 9
), (where
provided, in some cameras this is not necessary)
Switch on the circuit board of the interface through its switch
Switch the camera on
Verify after a few seconds that the LED of the interface flashes
Verify the functioning of the keypad: the green LED flashing indicates
“correct functioning”, the red LED indicates “command transmission”
Insert Hotshoe cable for the flash command in the camera’s ’Hotshoe”
Position the camera inside of the housing verifying that it is sitting in its
correct position
Insert all the cabling inside the housing, verifying that do not obstruct
the perfect sealing of the two O-Ring or that are going to be caught
between the rear part of the housing and the closing panel, avoiding the
perfect closure and watertight of the housing (se
e image 9
)
N.B. To take photos verify that inside the viewfinder of the camera you
can see the word PC. When you have taken a photo, the image remains
constantly on the display until any button on the keypad is pressed. At
this point the camera will reconnect to the board and inside the display
appears again the word PC. At this point it is possible to take another
photo or change settings
Disable the Auto-Sleep from the menu of the camera before closing and
sealing the housing verify the cleanliness of the O-Rings.
Close the housing placing first the lower part of the closing panel and
verifying that the locking latches and the securing catches are aligned. At
this point push the closing panel and lock securely with the locking latches
ensuring the housing is completely sealed and that the camera has been
inserted into the housing correctly.
As far as the remote command instructions are concerned please consult the
relevant instructions set in the Camera Mode in “Manual Mode”
Imagine 8
Image 9
Содержание Leo 2
Страница 1: ......
