EASYDIVE
di Fabio Benvenuti - Via dell’Industria 13 Int. 6 – 48015 Montaletto di Cervia (RA) -
Tel/Fax + 39 (0)544/962923 cell. + 39 338/9994219 - Web:
www.easydive.it
E-mail: [email protected]
Imagine 5
COMPATIBILITY
CANON EOS, NIKON, PENTAX, SONY, FUJI
and many others
Contact us to verify if your camera is compatible.
Use Modality
The Leo II has a sledge in which the digital camera has to be firmly fixed to.
Open the housing by releasing the locking latches, extract the sledge from the
housing and align the hole for connection to the tripod found at the base of the
camera with the screw of the sledge. With an adapt screwdriver tighten the screw
enough not to permit any movement, avoiding to over tighten it. Excessive
tightening could damage either the screw or the sledge (see image 4 e 5)
Inserting the camera into the Leo II housing.
(Aligning sledge and fixing to the camera body)
System FCUSB
The system FCUSB is made up of an interface USB set inside the housing which is
powered by two Ultimate Lithium AA batteries max 3V (not provided). We
recommend this batteries as they provide a constant 3V right to the end and
therefore always guarantee a perfect use. This interface allows to remotely
controlling all the commands of all the Digital SLRs through the external keypad.
In order to insert the batteries extract the battery container from the housing
pulling out in order to separate it from the Velcro straps (see image 6 & 7):
Insert batteries and press the container into his original position securing it over
the Velcro straps.
Turn on the circuit board through its own switch and ensure that the commands
of the keypad work prior to proceed with the other operations.
To verify that the batteries are fully
charged it is sufficient to watch that
green LED of the USB interface flashes
quickly (many times per second),
this signals that the batteries are fully
charged, the absence of this signal means that they are discharged and the
functioning is no longer guaranteed. The green LED means “active connection”,
the red LED indicates “connection not functioning”
(See image here below and above shown by the harrows)
Imagine 7
Imagine 4
Imagine 6
Содержание Leo 2
Страница 1: ......
