Figure 9
- Ignition Gap
TROUBLE SHOOTING
WARNING: Service and repair should only be
accomplished by a gas appliance technician or your
gas company.
Problem
- Main burner(s) will not light.
Solution
- Check gas shut-off valve is “ON.” Depending
on the gas line length, it may require further “bleeding” to
remove trapped air. If no gas is heard escaping the
burner, remove the burner and venturi assembly.
Carefully unscrew the burner orifice located at the end of
the gas valve. Inspect the orifice for blockage from
particles in the gas piping system (Do not clean the
orifice by forcing something through the metering hole).
Problem
- Ignitor will not spark.
Solution
- Push ignitor button and watch for sparking
between the electrode and ignitor box for the EC30 or
match light carryover for the EC24. If no sparks are
visible, replace battery by unscrewing the button top.
Additionally check the wire connections at the electrode
and ignitor. Test again and if no sparks are noted at any
electrodes, replace ignitor. If sparking at only one
electrode is noted, check electrode for clean grounding.
Check spark gaps between all electrodes. The gap
should be approximately 1/4"
(figure 9)
.
Problem
- Low flame and/or low heat output.
Solution
- Check the gas supply shut-off valve. Make
sure it is fully open. If the gas supply is an LPG tank,
check the gas quantity. Check pressure of gas supply
down stream from gas regulator. Make sure it meets
minimum requirements on rating label located on front of
the grill.
MAINTENANCE
Cleaning and maintenance should be performed at least
annually on your grill. The following check list will help:
1) Remove grids and stainless ceramic baffles.
Remove all loose materials from burners and
cabinet.
Brush area around igniter carefully removing grease
and residue.
Inspect burners for damaged areas.
Replace burners if there are any areas that appear
burnt through.
Replace components per assembly instructions.
2) Check gas supply lines, regulator, and valves for
signs of wear or distress.
Replace any items that show any signs of cracking or
burning.
3) Rotisserie burner units require the screen to be
cleaned. Carefully brush loose materials and
residue from the screen.
General cleaning may be accomplished by using a
household cleaning solution and warm water. The
exterior may be cleaned using the same method. Badly
soiled areas can be clean using a “scotch brite” pad.
Always scrub in same direction of material finish.
With proper care your
EasyChef
grill will give you years
of trouble free service. If you have any questions
regarding this product please contact - Customer
Service, Sierra Products, Inc., Monday thru Friday
8:00am to 4:00pm PST at (775) 241-2586.
For warranty qualification and coverage information,
see enclosed limited warranty sheet.
9
