Figure 3 - Gas Connection
Figure 4 - Baffle Placement
Figure 5 - Briquette Placement
1) Connect the gas regulator to the gas supply line
(down stream from the shut off valve). The
regulator inlet is marked by the “IN” or an arrow
showing direction of gas flow.
2) Connect a 3/8" stainless appliance connector to
the gas supply line (down stream from the shut off
valve)
(figure 3)
.
3) Route connector by turning a complete spiral loop
with connector outlet facing forward.
4) Slide grill head into opening and attach the
connector to gas inlet manifold on right rear.
5) Make certain all burner knobs are turned to the
“OFF” position. Turn main gas shut-off valve to
the “ON” position. Check all connections to the
grill by brushing on a 50/50 soap and water
solution. If any bubbles are noted, tighten
connection and re-check.
WARNING: Never check for leaks with an open flame.
6) Slide the grill back into position watching the
connector does not “kink” in the process (excess
stainless connector may be located under grill).
For further information GO TO “Component Assembly.”
CART, PEDESTAL, POST ASSEMBLIES
The
EasyChef
Grill may be assembled on one of the
following mountings available from your local dealer:
DESCRIPTION
EC24 P/N
EC30 P/N
Deluxe Cart
10655
10565
Pedestal Cart
10656
10592
Patio Base
10757
10756
Permanent Post
10657
10567
Follow the assembly instructions included with the
above-mentioned mounting assemblies. In-ground post
assemblies should be protected against corrosion as
warranted by soil conditions.
For further information
check the Permanent Post instruction.
COMPONENT ASSEMBLY
Now that your EasyChef Grill is properly mounted, there
are only a few short steps necessary to complete your
grill.
EGS - EasyChef Grill System:
1) Remove packing from the Stainless flame baffles.
Turn baffles at an angle and drop into the chassis.
Align the baffle, (4) tabs fore and aft for proper
position
(figure 4)
.
.2) Open bag of ceramic briquettes. Position
briquettes on each of the baffles as shown in
(figure 5)
.
Note:
There are (14) briquettes on the (5) baffles for the
EC30 for a total of (70) briquettes.
The EC24 has (11) briquettes on each of the (4) baffles
for a total of (44) briquettes.
3) Install (2) of the stainless grids onto the top
mounting rails.
4) Install the grease tray under the control panel
onto the slides.
5
