Easycar E8-B, Руководство по установке

Страница: 10 / 13

18
INSTALLATION GUIDE
19
INSTALLATION GUIDE
U S A U S A
C. Smart Door Lock Registration
1) Open the driver side door.
2) Make sure the Push-to-Start button is set to the “OFF” position.
(“START” light should be lit)
3) Press the II or button for 2 seconds on the 1st remote.
(Siren will beep twice)
4) Press the II or button for 2 seconds on the 2nd remote.
(Siren will beep twice)
5) Smart Door programming is now complete.
5. Remote/Push Button Start Diagnostics
When the remote start function is activated and the vehicle emits an error tone
(3 chirps); you have the ability to see what the cause of the no-start situation is by
counting the amount of flashes of the parking lights from the vehicle.
Number of parking
lights flashes
Cause of Error
1 Engine is on
2 Ignition is to the ON position
3
Door is open (Door wire is active) or Knock Sensor is not
programmed
4 Trunk is open (Trunk wire is active)
5 Brake is being pressed (Brake wire is active)
6 CN4/7 wire is not connected
7 Manual transmission mode is enabled and not initialized
8
Parking brake / Emergency brake is off
Neutral safety wire has no ground or the neutral safety switch
is off
B. Easy Door Lock Program
(Push button will not operate until Easy Door Lock is programmed)
1) Decide on a passcode, a 4 digit number. (i.e. 1234)
2) Step into the vehicle.
3) Open the driver side door.
4) Press the “Start” button so that it is on the “Ignition ON” position.
5) Step out of the vehicle.
6) Knock on the Easy Door Lock a few times until you see all the LED lights flash.
7) LED light will now move from 1 to 0.
(Each number will be lit for 2 seconds)
8) Knock on the pad when the number to your passcode is lit.
(Each time a number is entered, the LED light will restart from the 1 position)
i.e.) On a passcode for 1234.
a. Tap when the LED light is lit on the 1.
b. LED light will restart from the 1 position and move onto 2.
c. Tap when the LED light is lit on the 2.
d. LED light will restart from the 1 position and move onto 2 and 3.
e. Tap when the LED light is lit on the 3.
f. LED light will restart from the 1 position and move onto 2, 3 and 4.
g. Tap when the LED light is lit on the 4.
9) Once all 4 number passcodes are entered, the siren will beep once and the
parking light will flash once.
10) Easy Door Lock programming is now complete.