Easy-Laser XT11, Руководство пользователя

Страница: 43 / 81

MEASURE USING 9-12-3
The measuring positions are registered at positions 9, 12, 3 o’clock. The inclinometers are not used.
Preparations
Before you start measuring, make sure you have done the preparations you need.
l
Mount the measuring units.
l
To calculate results, you need to enter at least the distance between the measuring units, see "Enter distances"
on page 36.
l
If needed, perform a rough alignment. See "Set up measuring units" on page 34.
l
If needed, measure Softfoot, see "Softfoot" on page 37.
Measure
It is possible to switch measuring method before you have registered a value.
1. Tap on the tab to select the method 9-12-3.
2. Adjust laser to the center of the targets. If needed, adjust the units on the rods, then use laser adjustments knobs.
3. Turn shafts to 9 o’clock.
4. Tap to register the first position.
5. Turn shafts to 12 o’clock.
6. Tap to register the second position.
7. Turn shafts to 3 o’clock.
8. Tap to register the third position.
9. Tap to go to the Result view, or tap to measure again.
The registered values are saved when you leave the Measure view. If you return to the Measure view, it is possible to
do a new measurement.
A. The Measure icon is active in the workflow.
B. Tap to display detector information.
C. Yellow = registered position.
Green = turn shafts to green area.
D. Measurement table.
E. Delete registered value.
F. This icon is gray when it not possible to register a value.
43
HORIZONTAL