To order parts and supplies: 800.343.9353 >> eastwood.com
9
• Utilizing a combination square, verify alignment of the centerline of the Wheel
Axle to the Anvil Axle
(FIG 14)
. If adjustment is necessary, Loosen the Wheel
Yoke Tube Mounting Bolts so that it can be pivoted in the slot. Retighten to
40 foot-pounds (55 Nm) when aligned.
• Lay the straight edge at a diagonal across the Wheel and the Anvil
(FIG 15)
in
both directions
(FIG 16)
.
• The straight edge, ideally, should lay flush with both Wheel and Anvil faces.
However, a 1/8” [3mm] gap will not affect wheeling. If adjustment is necessary:
- Turn the Anvil Tube set screws in or out from opposite directions as needed
to move the Anvil and Wheel into alignment.
- With the alignment verified, the Anvil Tube set screws can be lightly
tightened.
DO NOT over tighten the Anvil Tube Screws as the Anvil Tube
needs to able to move up and down smoothly.
FIG. 14
FIG. 14
FIG. 15
FIG. 15
FIG. 16
FIG. 16
