8
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
WHEEL TO ANVIL ALIGNMENT
• For best results, Eastwood recommends verifying alignment of the Wheel and
Anvil with a straight edge before use.
To do so: Begin by loosening the Anvil Tube set screws
(FIG 10)
and raising the
Anvil to just below the Wheel by turning the Jackscrew.
• Check alignment of Anvil to the Anvil Tube with the straight edge
(FIG 11)
.
If necessary, loosen the Anvil Yoke set screws and rotate into alignment.
• Verify, visually, the Wheel Yoke and Wheel are centered left to right and parallel
with the Frame
(FIG 12)
. If adjustment is needed, the Wheel Yoke is slotted for
left to right adjustment. Loosen the Wheel Yoke Mounting Screws
(FIG 13)
to adjust.
• Raise the Anvil until it just touches the Wheel by turning the Jackscrew.
FIG. 10
FIG. 10
FIG. 11
FIG. 11
FIG. 12
FIG. 12
FIG. 13
FIG. 13