6
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
FIG. 13
FIG. 13
FIG. 14
FIG. 14
FIG. 15
FIG. 15
FIG. 12
FIG. 12
• With the Pedal facing upward, slide the sleeved end of the Foot Pedal
[F]
over the
Pivot Shaft and secure with the previously removed Locknut and Washer
(FIG 1)
.
NOTE:
Do Not overtighten and cause binding.
• Insert the threaded end of the Spring Eyelet
[W]
into the corresponding hole in
the face of the right Main Frame Side
[A]
and secure with the previously removed
nut and washer
(FIG 12)
.
• Hook the ends of the Foot Pedal Spring
[U]
into the Spring Eyelet and the tab on
the upper edge of the Foot Pedal arm
[F] (FIG 12)
.
• Set one end of the Linkage Arm
[G]
into the Clevis of the Hydraulic Pump Ass’y
Arm, slip a Linkage Clevis Pin
[X]
through the holes and secure with a Cotter Pin
[Y] (FIG 13)
.
• Place the opposite end of the Linkage Arm
[G]
into the clevis tabs of the Foot
Pedal
[F]
, slip a Linkage Clevis Pin
[X]
through the holes and secure with a
Cotter Pin
[Y] (FIG 13)
.
• Insert the (2) Table Support Pins
[H]
through the selected pair of 9 available
height setting holes in the Main Frame side members
[A]
and secure by snapping
the Table Support Pin Clips
[T]
into the annular grooves
(FIG 14)
.
• Assemble the Table from the Table Front and Back halves
[J]
&
[K]
and (2) Table
Spacers
[L]
with (4) sets of M10 x 1.50 x 130 Shoulder Bolts, nuts, washers and
locknuts
(FIG 15)
.
• Feeding it from above at an angle, install the assembled Table
[J]
,
[K]
&
[L]
between the Frame side members and resting on the Table Support Pins
[H] (FIG 16)
.
IF USING HAND CONTROL PUMP HANDLE
• Slide the Pump Handle
[M]
into the Pumping Lever of the Pump
[N]
.
• The Arbor Plates
[Z]
are placed as needed on top of the Table Assembly
[J]
,
[K]
&
[L]
to support the workpiece.
FIG. 16
FIG. 16