6
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
• Remove the outer nut and washer from the Spring Eyelet Ass’y
[V]
and set
them aside.
• Insert the threaded end of the Spring Eyelet
[V]
into the corresponding hole in the
face of the right Main Frame Side
[A]
and secure with the previously removed nut
and washer
(FIG 13)
.
• Hook the ends of the Foot Pedal Spring
[T]
into the Spring Eyelet and the tab on
the upper edge of the Foot Pedal arm
[F] (FIG 13)
.
• Insert the (2) Table Support Pins
[H]
through the selected pair of 8 available
height setting holes in the Main Frame side members
[A]
. Secure by snapping
the Spring Clips
[S]
into the annular grooves
(FIG 14).
• Feeding it from above at an angle, install the Table
[J]
between the Frame side
members and resting on the Table Support Pins
[H] (FIG 15)
. Retain the Pins
using the Table Support Pin Clips
[S]
.
IF USING HAND CONTROL PUMP HANDLE:
• Slide the Pump Handle
[K]
into the Pumping Lever of the Pump
[L] (FIG 15)
.
• The Arbor Plates
[Y]
are placed as needed on top of the Table
[J]
to support
the workpiece.
FIG. 13
FIG. 13
FIG. 14
FIG. 14
FIG. 15
FIG. 15
