© Copyright 2012 Easthill Group, Inc.
Instruction part #12740Q Rev. 6/12
If you have any questions about the use of this product, please contact
The Eastwood Technical Assistance Service Department: 800.544.5118 >> email: [email protected]
The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA
US and Canada: 800.345.1178 Outside US: 610.718.8335
Fax: 610.323.6268 eastwood.com
TROuBLEShOOTING
• The entire unit shuts off during use, switch is in the “on” position:
-The unit has overheated from exceeding the duty cycle and the internal thermal protection circuitry has been activated. Turn
the main power switch off, wait several minutes to allow cooling then turn power switch back on. The unit is ready for service.
-The power switch is on, the indicator light is illuminated, the fan is running however when the Torch activation button is
depressed, there is no sound from the Pilot Arc Igniter and there is no air flow:
-Check all connections. A loose connection will prevent Torch activation.
-Check for damaged lines, Torch or Torch Tip.
-Make sure there is sufficient air flow & pressure. (30 to 60 PSI)
• The power switch is on, the indicator light is illuminated, the fan is running however when the Torch activation button is
depressed, there is airflow through the torch but no sound from the Pilot Arc Igniter:
-Check all connections. A loose connection will prevent Torch activation.
-Check for damaged lines, Torch or Torch Tip.
-Inspect the Torch Tip for damage, excessive molten material build-up or excessive burning. Replace if necessary.
• The power switch is on, the indicator light is illuminated, the fan is running and when the Torch activation button is depressed,
there is airflow through the torch, the Pilot Arc Igniter is activating however a plasma arc cannot be started:
-Check all connections. A loose connection will prevent Torch activation.
-Check for damaged lines, Torch or Torch Tip.
-Inspect the Torch Tip for damage, excessive molten material build-up or excessive burning. Replace if necessary.
-Input voltage is too low or too high (below 110V or above 240V).
-Air pressure is too low or too high. (below 30 PSI or above 60 PSI), Adjust to proper pressure.
• The Pilot Arc is spattering:
-Lower air pressure to 60 PSI or below.
-Replace the nozzle and electrode in the torch.
REPLAcEMENT ITEMS:
• #12811
– Plasma Cutter Torch Assembly
• #12812
– Electrode 10-Pack
• #12814
– Nozzle 10-Pack
• #13787
– External Nozzle
• #13788
– Air Diffuser
