cARE AND MAINTENANcE
• It is extremely important that the air supply be clean and dry. A seprate
moisture trap, water/oil separator or desiccant system should be used.
The Versa-Cut Plasma Cutter has a built-in “last-chance” moisture
separator which requires draining each time you have completed work
with the unit. This feature is located on the underside rear corner and
is drained by keeping the unit level and gently pulling down on the drain
fitting. (Fig. E)
• Constantly inspect the torch tip for excessive erosion, molten metal
accumulation or burning. If damaged, it must be replaced.
• Before each use, inspect
ALL
electrical connections, cables, supply line,
torch, air supply, housing and controls for damage. If any damage or
wear is noted,
DO NOT USE THE UNIT.
• Always store the unit in a safe, clean and dry environment.
TORch MAINTENANcE
The Eastwood Versa Cut Plasma Cutter has a number of
consumable parts that will need to be replaced over time. If
wear or slag build up is noticed on any of the torch components,
replace them immediately to avoid damage to the torch. Worn
components will also contribute to poor cutting and difficult arc
starting. See the torch components (Fig. F) exploded view for a
reference of all of the components and the assembly order.
FIG. E
✑✒✓
✔
FIG. F
Electrode
Air
Diffuser
Nozzle
External
Nozzle
✑✒✓
✔
✑✒✓
✔
✑✒✓
✔
✑✒✓
✔
