6
EASTMAN
Encoder Assembly Installation
Position Encoder Assembly on four studs located on the
front frame. The encoder gear wheel must roll smoothly along
encoder gear belt. Fasten bracket with hardware provided
and install tension spring on encoder arm. Adjust tension so
gear wheel remains in continuous contact with gear belt as
the spreader moves.
Safety Cam & Limit Switch Installation
The Safety Cams and Limit Switch Assembly should now be
installed for safety. Mount the safety cams, as shown, at
each end of the spreading area. Loosen the limit switch
actuating arm and swing into position. Secure actuating arm.
Check for positive contact between actuator and cam. Plug
in main drive motor to mating plug. Replace covers and
secure in place.
WARNING
Safety Cam must strike the Actuating Arm and stop
machine when properly installed. Improper installa-
tion may allow machine to travel past ends of
spreading area causing a potential safety hazard.
Mast Installation
Push spreader to position directly under feed rail trolley.
Mount mast in operating position and secure mast with
hardware provided. Connect mast plug to machine inlet at
base of mast. Check voltage rating of trolley with electrical
rating stamped on serial number plate. If compatible, con-
nect mast cord to trolley and secure with chain.
Note: Feed rail voltage varying more than 10% (11v for 110 volt
machine, 22v for 220 volt machine) may damage your
system's electronics.
Installation of Folding Blades
Lower elevator blocks to their lowest limit with elevator down
button on control panel. Lift folding blades onto table at the
roll up chute side of the
CR 500. Mount folding blades onto
elevator blocks and secure with hardware provided. Connect
the roll up chute to the folding blades.
Installation of Moveable (Left) Clamp Catcher
Drop elevator blocks to their lowest limit of travel with elevator
down button on control panel. Place moveable catcher onto
table at the roll up chute side of the spreader. Push catcher
until pinbar engages folding blades. The folding blades must
slide and lock in place.
After the folding blades are locked in place, position the
pinbar roller studs in the slide assembly notches to lock the
catcher to the folding blades.
With catcher secure in slide assembly, drive spreader slowly
to the left by pulling the (Red) main power button out,
pressing the (Green) control button and turning the hand
throttle. Move catcher until pinbar (catcher) is above end
marker line. Clamp catcher to table. Lift the pinbar out of the
slide assembly and slowly drive spreader out of catcher.
Drive spreader slowly back into the catcher, checking for
proper operation of catcher and folding blades. Make any final
adjustments and lock catcher in place.
Содержание CR 500
Страница 8: ...8 EASTMAN Familiarization ...