EASTMAN CR 500, Инструкция по эксплуатации

Страница: 4 / 16

4
EASTMAN
The CR 500 Cradle Spreading Machine is shipped with a kit
containing parts and special tools necessary for proper
setup and operation. To get the best performance, familiarize
yourself with all the functions and adjustments of this
equipment. Before any operation can take place, it is
important that you carefully read and follow the instructions
in this manual in the same sequence in which they are
presented.
The following items listed below may be included with your
installation kit or purchased at a later date:
MS: Machine size in inches.
*: Optional equipment.
PART No. DESCRIPTION
9120-701 Encoder Track/Belt/Hardware
8' section
CR-02554 Safety Cam Assemblies (2),
Guide Wheel Style
SY-02310-MS Mast Assembly (110v)
SY-02310-1-MS Mast Assembly (220v)
11-2006-110 Trolley, Feed rail (110v)
11-2005-220 Trolley, Feed rail (220v)
9136-001 Allen Wrench Kit
Accessories
CR-04578-MS Flaw Cutter with Folding Blades
CR-04575-MS Reverse Roll Spreading Option
CR-04635-MS CR Heavy Duty One-way Knifebox
CR-04531-MS CR Catcher, One-way Knifebox
Consult Factory Two-way Knifebox
SY-04208-MS Folding Blades
QC-04495-MS Quick Clamp Catcher
SY-04196-MS Stationary Catcher
TPL-04310-1 On-Floor, Operator Platform
TPL-04462 Off-Floor, Operator Platform
TPL-0402 6'2" Style, Operator Platform
MS = Machine Size
System Documentation
CR-50-0445 Eastman CR 500 Manual
INSTALLATION
Table Preparation
The spreading table required must be smooth and level along
its entire length. A minimum 3 feet (1M) clearance around the
entire table is required for safe operation.
To Level Table
Use carpenter's level to check spreading table. Be espe-
cially careful to make sure table joints mate closely. Adjust
table feet as necessary to level table.
Track Installation
The
CR 500 requires an encoder track to feedback spreading
information to the microprocessor and Guide Wheels to
guide the machine along the table edges. Optional Guide
track is available. Install the track at this time.
Magna Track or Z-Track Installation
Place track sections along table top, end to end, on the
operator's side of the table as they will be mounted. Mount
the track as shown. Make sure the joints in track are even and
DO NOT align with seams in table. Be sure track is mounted
firmly to table.