Ultimate SLIDE WALL installation Step #6
Install top wall rail, WR2496
flush with top of post using 2 - 3”
lags on each side.
NOTE: Rail should extend 20½ ”
from post on each side.
Place bottom wall rail, R2429 on
floor and install into left post
using 2 - 3” lags. Make sure the
slide opening is on the right.
Install tent support TS4484 to
the center of WR2496 and to the
side of R2429. Using 2 - 3” lags
on top and bottom. Make sure
you level your tent support 4x4
before installing lags.
SLIDE Wall
WR2496
R2429
20½”
Layout 3 - WB54440 wall boards
on the inside of clubhouse against
rails just installed.
Measure 3½” in from TS4484 tent
support and install your first wall
board With 1-3/4” screws. Now
measure 3½” in from P4414 post
and install second wall board with
1-3/4” screws . Now install your last
wall board in center of the two wall
boards with 1-3/4” screws.
NOTE:
3½” Openings off post and
tent support are important to be
correct for this is the location of
monkey bars to be install later.
3½”
3½”
20½”
T
S
4
4
8
4
15
