23
22
EASTOAK.COM
TABLETOP PATIO HEATER
OWNER’S MANUAL
ASSEMBLY INSTRUCTIONS
• Do not store a spare propane gas cylinder under or near this appliance;
• Never fill the cylinder beyond 80 percent full;
• Place the dust cap on the cylinder valve outlet whenever the cylinder is not in
use. Only install the type of dust cap on the cylinder valve that is provided with
the cylinder valve. Other type of caps or plugs may result in leakage of propane.
WARNING
The pressure regulator assembly supplied with the appliance must be used.
Replacement pressure regulator assembly must be that specified by the appliance
manufacturer.
The propane cylinder must be constructed and marked in accordance with the
specifications for propane gas cylinders of the U.S. Department of Transportation
(DOT) or with the Standard for Cylinders, Spheres and Tubes for Transportation of
Dangerous Goods and Commission, CAN/CSA-B339. The propane cylinder must
include a listed overfilling prevention device. The propane cylinder must include a
cylinder connection device compatible with the connection for the appliance. The
cylinder used must include a collar to protect the cylinder valve. Never connect an
unregulated propane cylinder to the heater.
OPERATION INSTRUCTIONS
1. This portable heater is intended for outdoor use only.
Always ensure that adequate fresh air ventilation is
provided.
2. Always maintain proper clearance to combustible.
materials, i.e. top 24 inches and sides 36 inches
minimum.
3. Never operate the heater in an explosive
atmosphere like in areas where gasoline or other
flammable liquids or vapors are stored.
4. The heater must be fixed on a stable and strong
table with a minimum height of 1300mm from the floor
level.
Gas connections on this heater are
leak-tested at the factory prior to
shipment. Possible mishandling of
this appliance during shipping may
impair product integrity. Perform
a complete leakage test again at
the installation site following the
procedure below:
1. Make a soap solution of one part liquid detergent and one part water. The soap
solution can be applied to hoses and connections with a spray bottle, brush or rag.
2. Make sure the safety control valve is in the "OFF" position.
3. Turn the cylinder valve ON and check for soap bubbles forming on and around
connections and hoses. If bubbles appear, there is a leak present.
4. If a leak is present, remove the gas cylinder immediately, tighten any leaking fittings,
replace the gas cylinder, and recheck.
PORTABLE HEATER LOCATION
TESTING FOR LEAKAGE
CEILIN G
24 in.
36 in.
WALL
1
2
Cylinder
connection
Regulator
/ Cylinder
connection
Hose
/ Regulator
connection
