Operator’s Manual
Rototiller Victory
10
For additional information email
or call 800-345-6007 M-F 8-5
UNPACKING AND ASSEMBLY
Your rototiller comes fully assembled except for a few parts.
The following instructions will help you unpack your tiller and
assemble and adjust your tiller’s depth regulator lever, cable
tension and handle bar height. You will need one 16 mm and
one 17 mm wrench.
Carton Contents:
•
Rear Tine Rototiller w/Handle Bar
•
2 - Side Shields
•
2 - Wheels
•
Depth Regulator
•
Parts Bag
Tools required for assembly:
16 mm & 17 mm wrenches
Unpack Tiller and Assemble
1. Open top of carton and remove handle bar assembly.
2. Find parts packet. Parts packet contains:
•
M10-1.5 x 45 mm hex head bolts
•
M10-1.5 x 25 mm hex head bolts
•
M10-15 mm nylock nuts
•
M10 flat washers
•
M6-1 x 12 mm hex head bolts
•
M6-1 nylock nuts
•
1 - lock pin
•
12 - M6 flat washers
•
2 - Handle bar extensions
•
2 -linchpins
NOTE: Parts packet also includes Engine Manual,
Warranty Registration Card and this Operator’s
Manual.
3. Cut open seems of carton, exposing all contents and
remove machine by:
a. Attach loose wheels in box onto machine with wheel
lock pins in free-wheel position. Slide wheel all the
way onto the axle and insert linchpin through the axle
hole only.
SEE FIGURE 2
b. Roll tiller from carton.
Install depth regulator:
1. Locate depth regulator and lock pin.
SEE FIGURE 3
2. Unscrew adjusting knob from the top of the depth
regulator and slide depth regulator up into vertical slot at
the rear of the tine shield.
SEE FIGURE 3
3. Reattach the adjusting knob to the top hole of the depth
regulator.
4. Insert lock pin through the hole in the vertical slot and a
hole in the depth regulator to hold it in place.
FIGURE 3
DO NOT LIFT THE ROTOTILLER FROM THE CARTON.
ROTOTILLER IS HEAVY AND CAN CAUSE INJURY. CUT
BOX AWAY FROM ROTOTILLER AND REMOVE BOX.
WARNING
FIGURE 2
WHEEL LINCHPIN IN FREE-WHEEL POSITION
(LINCHPIN IN AXLE HOLE ONLY)
ADJUSTING
KNOB
DEPTH
REGULATOR
LINCHPIN
