Eagle FishElite 320, Инструкция по установке и эксплуатации

Страница: 146 / 200

138
vice, such as an autopilot. The com port can be used for either NMEA,
DGPS or SiRF Binary data transfer.
Menus for changing Com Port settings.
For connectors and wiring information for another device, see page 32.
For assistance in configuring the unit to communicate with another
device, consult the factory; customer service phone numbers are in the
back of this manual. Also see the entries below for
Configure DGPS and
Configure NMEA . To set Com Port Configuration:
1. Press
MENU
|
MENU
|
↓
to
S
YSTEM
S
ETUP
|
ENT
.
2. Press
↓
to
C
OMMUNICATIONS
P
ORT
|
ENT
.
Configure DGPS
This unit will recognize Starlink

, Magnavox

and Lowrance DGPS
receivers.
1. Press
MENU
|
MENU
|
↓
to
S
YSTEM
S
ETUP
|
ENT
.
2. Press
↓
to
C
OMMUNICATIONS
P
ORT
|
ENT
.
A. If you have a Magnavox receiver, press
↓
to
M
AGNAVOX
|
ENT
.
B. If you have a Lowrance or Starlink receiver, press
↓
to
S
TARLINK
|
ENT
.
C. If you have a Magnavox or Starlink, press
EXIT
|
EXIT
|
EXIT
. This is
the only setup necessary. If you have a Lowrance receiver or another
Magnavox- or Starlink- compatible brand, continue with these steps:
3. Press
↓
to
C
ONFIGURE
NMEA
|
→
to
C
ONFIGURE
DGPS
|
ENT
.
4. Press
ENT
, then use
↑ ↓ → ←
to enter the station frequency, then
press
ENT
.
5. Press
→
to
B
IT
R
ATE
|
ENT
then use
↑ ↓
to select the station bit rate,
then press
ENT
.
6. A. If you are not using a Starlink DGPS receiver, press
EXIT
|
EXIT
|
EXIT
|
EXIT
to return to the previous page.
B. If you are using a Starlink DGPS receiver, press
↓
to
S
TARLINK
A
UTO