Eagle 2000F Series, Руководство по эксплуатации

Страница: 23 / 49

- 23 -
5.1 Troubleshooting Guide
Problem Possible Causes Solution
Carriage
does not run.

Check to see if the machine is plugged in.

Check carriage speed knob is at minimum
position – if so turn carriage speed knob to a
higher setting.

Check to see if the chain is broken or
disconnected.

Carriage sliding block is jammed – realign slide
block.

Plug machine into adequate
power 110 Volt outlet.

Replace chain or reinstall chain /
remove any debris.

Loosen slider blocks to realign
and lubricate with a dry lube.

Adjust speed potentiometer to
correct speed.
Film breaks.

Speed is not set well between load force and
turntable speed – adjust the settings.

Check for cuts in film.

Move dancer bar without film to see if motor
turned on.

Pre-stretch chain is broken or jammed –
reinstall chain or refasten chain wheel.

Replace roll of film.

Faulty drive / look for rdy on
display. May need replaced

Replace chain or reinstall chain
and tighten all hardware.

Adjust speed potentiometer to
correct speed.
Scale does
not work

Is the machine level.

Are all of the leveling feet in the proper place?

Start by placing the machine on
a flat surface and using a level.

Using the leveling feet supplied
and screw into load cell
Notes: