![background image](http://html1.mh-extra.com/html/eagle-group/q-lever-unit-with-all-wire-shelving/q-lever-unit-with-all-wire-shelving_assembly-instructions-manual_3298693005.webp)
X-brace
locations of holes for
attaching bottom half of
X-brace and bottom brace
5
ASSEMBLY INSTRUCTIONS
Q-LEVER Cantilever Shelving
(continued on next page)
Step 5 - Pre-level unit.
• Position frame at desired location.
• Adjust feet until front of unit is level (see
figure 5a
).
• No need to level unit so that shelves are higher at
front than at the rear of unit. Shelves designed with
positive slope.
If your unit came
with a bottom
dunnage shelf,
place the shelf
mat atop the
dunnage shelf.
Align (3) holes on bracket with
(3) pegs on upright at desired
height, and place bracket.
Snap QLOK onto bottom pegs
(both sides of upright) to
secure bracket to upright.
Bracket shown secured
to upright.
Install opposite bracket at same height.
shelf
mat
bracket
brackets
dunnage
shelf
QLOK
Quick Note…
QLOK in place
bracket
upright
Step 6 - Install brackets onto uprights at desired location.
Quick Note…
Step 4 - Assemble BRACE and bottom of X-BRACE
to bottom of uprights.
• Rearrange so that bottom of X-BRACE is OVERLAPPING the
BRACE (see
figure 4a
).
• Align holes of X-BRACE and BRACE with bottom hole on rear
side of upright.
• Run 5/16–24 bolt through lock washer and washer (hardware
provided), and through holes (see
figure 4a
), but do
NOT
tighten yet.
• Repeat on other end.
figure 4a
brace
X-brace
If your unit came with
a bottom wire shelf,
then proceed to
Step 6.
holes for
level position
holes for 15˚
angled position
Depending on which set of
holes are used, brackets can
be installed either level or at
an optional 15˚ angle.
Bracket installed at
optional 15˚ angle
figure 5a