13
Driving principle of common lifter:
Press “RISING” button,
the contactor is power on, the motor is also power on and in operation,
the motor drives oil pump, the hydraulic oil is input to lower cavity of
oil cylinder through one-way valve and oil pipe, piston driven by oil
pressure pushes oil cylinder to pass steel wire rope and rope wheel
set and drags bracket arm for rising so as to complete hoist. When
the vehicle is in maintenance, press falling handler, mechanical lock is
in safety status and the operator can conduct vehicle maintenance.
Press “RISING” button firstly in falling, make machine rise for about
20mm, unlock safety lock and press falling handler to make machine
fall.
Chapter V Equipment Installation and Commissioning
Carefully read the manual, make clear the structure and inspect whether there is damage
in transportation or loading& unloading and whether accessories are complete before
machine installation. Then the installation and commissioning shall be conducted in
procedures as follows. (The product shall never be connected outdoors)
1. The equipment shall be installed on the ground where there is no dust, pollution or
humidity , the horizontal error is not less than 5mm, the concrete thickness is more than
300mm and the strength is 3,000PSI
˄
2.1Kg/MM2
˅
, basic dimension is 4,000MM long,
1,000MM wide and 400MM deep; It is proposed to add steel bar and consolidate ground
fastness. (See foundation installation diagram). The foundation installation diagram shall
be selected according to machine type in selection.
Two post series lift foundation Diagram
Foundation installation diagram
M18*160 expansion bolt
(10 sets)
Concrete
strength
is
3000PSI (2.1kg/mm
3
)
PANZITTA SALES & SERVICE
72 George Avenue
Wilkes-Barre, PA 18705
570-822-6720 800-822-6720
www.panzittasales.com
