Product Manual RCUXXYY
EAE KNX Room Control Unit
RCUXXYY PM R1.0
©
EAE Technology
www.eaetechnology.com
Page 76 / 80
0 = operation enable
1 = operation disable
106
Forced operation 1 bit
Output A
DPT 1.003
1 bit
CWTU
If the telegram is received (value 1), the blind is moved to parameterized position and the blind is locked
for the movement command. After the forced operation is disabled by the object (value 0), the blind is
moved to parameterized position.
The object is;
0 = operation enable
1 = forced active / operation disable
106
Forced operation 2 bit
Output A
DPT 2.002
2 bit
CWTU
If the telegram is received value 2 or value 3, the blind is moved to UP (2) or DOWN (3) and the blind is
locked for the movement command. After the forced operation is disabled by the object (value 0) or
(value 1), the blind is moved to parameterized position.
The object is;
0 = operation enable
1 = operation enable
2 = forced active, move UP / operation disable
3 = forced active, move DOWN / operation disable
107
Status height 0…255
Output A
DPT 5.001
1 byte
CRT
The blind position of drive is available as a value 0…255 percentage %0…%100. The height status is to be
transmitted or read out via this object.
The height status object is only updated when the blind has reached a target position after movement.
The object is;
0
= upper end position %0
…
255
= lower end position %100
108
Status slat 0…255
Output A
DPT 5.001
1 byte
CRT
The blind slat position of drive is available as a value 0…255 percentage %0…%100. The slat status is to
be transmitted or read out via this object.
The slat status object is only updated when the blind has reached a target position after movement.
NOTE:
This object is only available in the venetian blind type.
The object is;
0
= slat open %0
…
255
= slat close %100
109
Status upper end position
Output A
DPT 1.011
1 bit
CRT
The blind is reached the upper end position, the device sends information.
The object is;
0 = the blind is not in upper end position
