Installation, Operation and Parts Manual
EE-MR35
13
S/N
Name
Specification
Qty
1
MR35 Mechanical Assembly
MR35-00
1
2
Portable kit
Optional
2.1
Wheel
MR30-A25-B1
2
2.2
Prop trough
MR30-A25-B2
1
2.3
All directional wheel
MR30-A25-B3
1
3
Feet protection fenders
MR30-A1-B7
2
4
Power and control unit
MR30-A24
1
5
Rubber pad
38*120*100
4
6
Hex socket cylinder head screw
M8*12
4
4.2 Installation attentions
4.2.1 Joints of oil hoses and wires must be well connected in order to avoid leakage of oil hose and looseness of electrical wires.
4.2.2 All bolts should be firmly screwed up.
4.2.3 Do not place any vehicle on the lift in the case of trial running.
4.3 General Installation Steps
Step 1: Place the lifting platform at expected installation site.
Please do read and understand this manual thoroughly before next step.
Step 2: Dismantle the package of the lifting platforms.
Remove the carton and packing films wrapped on the platform.
Avoid scratching the paint and hoses.
Step 3: Open the package of the control cabinet and take out accessories in it.
Step 4: Connect oil hoses.
Refer to Annex 3.
Connect the fitting of oil hose and its tie-in on the hydraulic block tightly.
Attention: Do not contaminate the hydraulic components during the connection.
Step 5: Connect electrical system.
Refer to Annex 2.
Read the name plate of the motor and understand the wiring diagram before connecting the power supply.
Open the control box and connect electrical wires respectively with the terminals reserved in it.
Pay attention to the number tubes attached with each wire. Wires and terminals with the same number marking are going to be connected
together.
Step 6: Fill with hydraulic oil.
CLEAN AND FRESH OIL ONLY. DON’T FILL THE TANK COMPLETELY FULL.
Lift must be fully lowered before changing or adding hydraulic oil
Prepare 5 liters of hydraulic oil. The level of oil shall reach the tippets volume mark of the tank.
Add more oil after running the lift for several cycles until the lift can rise to the maximum lifting height.
Note
：
I
t is suggested to use HM NO.46 hydraulic oil. Use HM NO.32 hydraulic oil when average temperature of the location is 10 degree
Celsius.
Change the oil 6 months after initial use and change once per year thereafter.
